Hall effect sensor designed for use in applications where ferrous
edge detection/near zero speed sensing is needed. They provide a sinking current output.

Typical automotive applications include:

• Crank & Cam Signals
• Speedometers
• Anti-lock braking systems

Box Contents
1 x Hall Effect Sensor
1 x DTM3 Connector Kit Set (Matching set, Male & Female connectors, pins & wedges)

Features

• From near zero speed up to 15 kHz sensing capability
• 10 bit dynamic threshold direction offers: Automatically adjusting magnetic range, Self-compensating to target geometry
• Compatible with unregulated power supply
• RoHS compliant
• IP67
• Typical air gap of 1.5 mm

Specifications

• Thread = M12x1.0
• Lead Length = 1m (20 AWG)
• Pin Out: Brown = Supply VCC Blue = Ground Black = Output V Voltage = 5v - 24v
• Max Current Draw = 6 mA
• Maximum Speed Detection = 15 kHz
• Maximum Installation Torque Limit = 5.65 Nm (50 in lb) on thread
• Recommended External Pull-Up Resistor: 5 Volts
• DC = 1k Ohms 9 Volts DC = 1.8k Ohms 12 Volts
• DC = 2.4k Ohms 15 Volts
• DC = 3k Ohms 24 Volts
• DC = 3k Ohms
• Operating Supply Voltage = 5 to 24 VDC Maximum Input Voltage = 30 VDC Maximum Reverse Voltage = 24 VDC Supply Current = 3 mA typ., 6 mA max Output Sink Current = 20 mA max
• Housing Material = Anodized Aluminum Operating Temperature = -40 °C to 125 ͼC Ingress Protection = IP67 Sensor Length = 65.5mm (2.58 inches)
• For best results, we recommend targets made from low carbon cold rolled steel.
• Other factors that influence sensor performance include gear tooth height and width, space between the teeth, shape of the teeth and thickness of the target.
• As a general guideline, consider a target with minimum parameters as shown below.
• Note that smaller dimensions may work, but testing for the application is required.
• Tooth Height - 5.0 mm (.200") Tooth Width - 2.5 mm (.100") Distance between Teeth - 10 mm (.400") Target Thickness - 6.35 mm (.250")